Pioneer pdp r05e instruction Incorrectly inserted reciever without cover. Now the red and green st. In the service manual deducted that this is the end of the cover TRAP SW. As on the panel, the reset was found, and how to do it in the receiver is not. Tell me, please, how to reset this error.
The key to the apartment where the money is not to give? Then use it to clean the dust in the receiver. Among other things, the fan was muffled.
From it, as always, it turned out. The fan does not ruffle, and the plasma does not work.
Specifications of the Pioneer Plasma PDP-504PU. As it works with a separate media receiver and video switcher, the Pioneer PDP-R04U. View, read and download service manual for PIONEER PDP-R04U, learn how to repair it, fix failures or solve other issues.
Newbie Posts: 26 Thanks, Hakob! Tried many options - the system is silent. I can describe how everything is: Panel-435PE, receiver-R05E Network cables are connected, two cables connect the Panel and Receiver.
I press the power button on the Panel - the red indicator starts blinking. I press the power button on the Receiver - the red indicator lights up, after a second green and light up together, after two seconds the fan starts to work, while the red indicator stops blinking on the Panel and then the fan in the Receiver stops after 5-7 seconds. Through DN did various combinations that are written in the manual - the system will not blink, it is silent. If you disconnect the cable (connecting the Panel and the Receiver) - on the Panel, the indicators start blinking one after the other at a 0.5 second interval, if you press the 'Power' button on the remote control, the Panel will turn on and two large squares will blink on the screen. Tried to put a jumper on TRAP SWITCH - no result. It seems that I did not miss something.
The participant of the message: 246 To the button i + find, it on the panel is sometimes wiped and you not that zhmesh the first. The combination is the same: you need to press correctly. Lock the TRIP SWITCH switch and turn on the plasma in the STAND BAY, 2. On the remote control, press the button. (i +) and hold for 5-10 seconds, 3. Press (LEFT, AR, LEFT, WRIGHT, RIVER, 4.
Quickly (within no more than 3 seconds). The plasma will switch to the FACTORY MOD mode in the INFORAME option, 5. MUTE 5 times - the plasma will switch to the INITIALIZATION mode, 6. Then press the key. (i +) for 5 seconds.
- reset operation completed. Turn off the power, turn on the power again. The procedure is finished. Newbie Posts: 26 Thanks, everybody! Many thanks to Hakob for the files provided!
The combination of the keys I did not work. I had to solder the EEPROM chip. Dumped the locked firmware from it and began to write down backups of different receivers. From one - the system showed 2 seconds and turned off with error 8. Another was blocked, the third one was launched, but the image was mirrored horizontally. I took these four firmware and compared: The change found in the address h20 and h21, when the system is locked, the system writes '0' to these addresses. If you merge the firmware of the locked receiver, change the values of these addresses to '1' and record it again - you will get an unlocked system.
Do not forget about the switch 'trap'!!!!!!!!!!!!!!!